
Flywheel energy storage (FES) works by accelerating a rotor () to a very high speed and maintaining the energy in the system as . When energy is extracted from the system, the flywheel's rotational speed is reduced as a consequence of the principle of ; adding energy to the system correspondingly results in an increase in the speed of th. Putting electricity through the coils creates magnetic fields that attract and repel the poles of the permanent magnets. That interaction causes the rotor to turn. Keeping it spinning requires constant changes in the magnetic fields. [pdf]
More recent developments include the REGEN systems . The REGEN model has been successfully applied at the Los Angeles (LA) metro subway as a Wayside Energy Storage System (WESS). It was reported that the system had saved 10 to 18% of the daily traction energy.
If the actual power output of the flywheel energy storage motor is left unchanged when a symmetrical fault in the grid occurs, it will result in the converter's overcurrent limitation on the grid side and a power imbalance on the DC-side.
Designing a motor to turn electricity into movement is tricky. In a typical motor, a component called a rotor turns inside a stationary component called a stator. One of those components contains permanent magnets that have south and north poles. The other has wire coiled around it.
At times when there is more electricity supply than demand (such as during the night or on the weekend), power plants can feed their excess energy into huge flywheels, which will store it for periods ranging from minutes to hours and release it again at times of peak need.
S4 Energy, a Netherlands-based energy storage specialist, is using ABB regenerative drives and process performance motors to power its KINEXT energy-storage flywheels, developed to stabilize Europe’s electricity grids.
In 2022, China's total installed capacity of flywheel energy storage climbed by 115.8% year over year. With the massive expansion of China's new energy, “new energy + energy storage” has emerged as a key strategy for addressing the issue of consumption.

In 2021, only oil accounted for 68.2% of Syria's total energy supply. Natural gas accounted for 30.9% and Water energy(hydro) accounted for 0.7%. From 2000-2021, 22 Metric tons of C02 has been emmited, which contributes to 0.07% of total energy emissions and a 41% decrease in CO2 emissions. Electricity consumption per capita has decreased by 43% between this period, with a 4.5% share of power generation on renewables in 2021 alone. [pdf]
In Syria, most energy is based on oil and gas. Some energy infrastructure was damaged by the Syrian civil war. In the 2000s, Syria's electric power system struggled to meet the growing demands presented by an increasingly energy-hungry society.
This infographic summarizes results from simulations that demonstrate the ability of Syria to match all-purpose energy demand with wind-water-solar (WWS) electricity and heat supply, storage, and demand response continuously every 30 seconds for three years (2050-2052).
In 2021, Syria's Ministry of Electricity estimated total losses to the electricity sector at USD 2.4 billion due to infrastructural damage and acute shortages of fuel and water needed to power Syria's thermal and hydroelectric infrastructure.
Energy demand in Syria has been increasing at a rate of roughly 7.5% per year due to the expansion of the industrial and service sectors, the spread of energy-intensive home appliances, and state policies that encouraged wasteful energy practices, such as high subsidies and low tariffs.
Estimated long-term, full-time jobs created and lost in the Mideast as a whole and in Syria itself when interconnected to the Mideast, due to transitioning from BAU energy to 100% WWS across all energy sectors.
The conflict in Syria led to increasingly frequent blackouts across the country due to damage to the electricity system. This resulted in disruptions to all forms of economic activity and reports of electrical fires caused by problems with the electrical grid.
We are deeply committed to excellence in all our endeavors.
Since we maintain control over our products, our customers can be assured of nothing but the best quality at all times.