To maximize solar radiation absorption, the interior bottom of the basin painted with black paint. The double slope of the solar still has a lower side at 0.15m and an upper side at 0.441m. The top glass cover, inclined at a 30 o angle towards the East and West, is 0.004m thick to enhance solar radi
Contact online >>
Furthermore, research indicates that the horizontal position exhibited better energy storage characteristics than the vertical position (Kousha et al., 2017;Rajpoot et al.,
The wt% of nitrogen is controlled by varying the wt% of palm flowers and melamine. The charge storage performance of NAC from palm flowers has been examined in aqueous, ionic liquid,
Sensible thermal energy storage (STES) with water as the heat storage medium is widely used for its low cost and simple structure, but its energy storage density is relatively
Storage energy and electrochemical sensing Keywords Waste biomass · Carbon aerogel · Energy storage · Hg sensing · Oil adsorption 1 Introduction With the development of the economy and
To maximize solar radiation absorption, the interior bottom of the basin painted with black paint. The double slope of the solar still has a lower side at 0.15m and an upper side at 0.441m. The
1. Introduction. The global energy demand is rising significantly day by day due to population growth and industrial demands. In addition, the most critical human-being problem
Abstract. Layered double hydroxides (LDHs) are clay networks with brucite (Mg(OH 2)) layers that are coupled with anions between the produced layers.The building structure of LDHs follows
Latent heat thermal energy storage systems exhibit a significant performance over other thermal energy storage systems. The performance of these particular systems during melting/solidification is
Sorour et al. [34] examined the influence of inclination angle on the melting behavior of a double-tube thermal storage unit experimentally and numerically. The horizontal
On the study of the ellipse angle, the results reveal that lower melting time is achieved for a higher angle while the solidification time is not varied significantly. In this
Figure 1 shows the schematic of double-effect absorption air chiller system. This system consists of four main flow circuits, which are solar collector, generator, cooling water and chilled water.
In this study, activated carbons (ACs) were produced from oil palm leaves (OPL) and palm kernel shells (PKS) using different concentrations (0%, 11%, and 33%) of H3PO4 as the activating
A double pass solar air heater of 750 The heater was tilted with an angle of 9° 11'' (local latitude angle) with respect to the horizontal position facing south direction to receive
As can be seen in Table 1, the present study is unique in proposing a novel modelling method for total solar energy input of a double-slope solar still based on all the geometrical parameters that can individually affect the device structure and consequently the overall solar energy input to the solar still.
However, the model derived for a double slope solar still was based on the inclination angles of the two glasses covers. This article has identified six main geometric parameters that determine the whole structure geometry of double-slope solar stills and their overall solar energy input.
Elango and Murugavel (2015) experimentally investigated the performance of single and double glass basin double slope solar stills. Stills were investigated at different water depth (1–5 cm) under insulated and uninsulated conditions. Insulated double basin still gave higher distillate output at lower water depth (1 cm).
Hence, by the results shown in Figure 11, it can be concluded that the effect of solar still azimuth angle on the glass covers’ incident angle, and therefore on the amount of total input energy, is negligible.
The sensitivity analysis also showed that the solar still tilt angle is highly effective on the total energy input. However, the device azimuth angle did not suggest significant effects on input energy.
The channel attachment of solar still performance is better than the without channel attachment of solar still (DSSS), due to evaporation heat transfer coefficient is very high in the channel attachment of solar still. It is shown in Fig. 12, Fig. 13. Fig. 11.
We are deeply committed to excellence in all our endeavors.
Since we maintain control over our products, our customers can be assured of nothing but the best quality at all times.